Novol High Gloss CLEARCOAT (500 ml)

Novol High Gloss CLEARCOAT 500 ml – High-gloss spray clearcoat

Novol High Gloss CLEARCOAT 500 ml is a one-component, thermoplastic spray clearcoat designed primarily for small repairs, spot repairs and local clearcoat applications. The product offers very good flowability, fast drying and an easy-to-polish surface.

The spray format is a practical solution for repair jobs where a full panel does not need to be clearcoated, but an even, high-gloss and visually clean finish is still required. The FAN nozzle provides a wider spray pattern than a standard aerosol nozzle and gives application properties similar to a spray gun, helping to create controlled and even coats.

Novol High Gloss CLEARCOAT is a colourless, high-gloss clearcoat suitable for automotive refinishing work, smaller body panels, repaired surfaces and partial clearcoat zones. With proper surface preparation and application, it forms a smooth, glossy and easily polishable protective layer.

Main benefits

• One-component thermoplastic spray clearcoat
• Recommended especially for small repairs and spot repairs
• Very good flowability for a smoother clearcoated surface
• Easy-to-polish coating
• Fast drying: approx. 1–2 hours at 20 °C
• Creates a high-gloss, colourless clearcoat layer
• Equipped with a FAN nozzle that provides a spray pattern similar to a spray gun
• Practical 500 ml aerosol packaging
• Suitable for automotive repair refinishing work

Product information

Area of use

Application instructions

1. Preparation: the surface must be clean, dry, degreased and properly prepared.
2. Shaking: shake the can thoroughly for at least 2 minutes before use.
3. Application: apply the clearcoat in 2–3 even coats.
4. Flash-off between coats: allow approx. 5–10 minutes between coats.
5. Drying: the clearcoat dries in approx. 1–2 hours at 20 °C.
6. Valve cleaning: after use, turn the can upside down and spray for approx. 5 seconds until the valve is clear.

Application data

Important warning

• Always clean the valve after use.
• To clean the valve, turn the can upside down and spray for approx. 5 seconds until the valve is clear.
• Use only on clean, dry and properly prepared surfaces.
• Always perform a test spray before final application.
• Workplace safety instructions and the safety data sheet must be followed.