Car-Rep RAL1002 Sand Yellow Vinyl & Leather Spray 400 ml

Car-Rep RAL1002 Sand Yellow Vinyl & Leather Spray 400 ml

Car-Rep Vinyl RAL1002 Sand Yellow is a flexible spray paint specially developed for renovating, repairing and recolouring automotive interior surfaces. It is designed for vinyl, leather and synthetic leather surfaces and is suitable for dashboards, door panels, seats, centre consoles, gear gaiters and other interior trim parts.

The special formula contains a built-in adhesion promoter, so no separate primer is required on properly prepared surfaces. The coating flows evenly and forms a durable, flexible finish that does not crack, peel or flake under normal use.

The finished coating has a semi-gloss appearance in RAL1002 Sand Yellow. It is particularly suitable for restoring worn, faded or discoloured automotive interior components.

What can it be used for?

• Renovating vinyl and suitable leather car seats
• Painting and restoring dashboards
• Door panels and interior door trims
• Centre consoles
• Gear gaiters and other interior trim parts
• Recolouring vinyl and synthetic leather surfaces
• Restoring worn or faded automotive interior components

Main benefits

• Designed for automotive vinyl, leather and synthetic leather surfaces
• Built-in adhesion promoter
• No separate primer required on properly prepared surfaces
• Permanently flexible coating
• Does not crack, peel or flake under normal use
• Excellent flow and even application
• Semi-gloss finish
• Fast drying
• Heat resistant up to +150°C
• Easy aerosol application

Product information

Simple instructions for use

1. Clean the surface thoroughly.
   Remove all dust, grease, silicone, wax, care products and other contamination. The surface must be completely clean and dry.
2. Matt the surface if necessary.
   Lightly mat glossy, damaged or previously painted surfaces if required, then clean thoroughly again.
3. Carry out a test spray.
   On unknown materials or existing coatings, check adhesion and colour first in an inconspicuous area.
4. Shake the can thoroughly.
   Once the mixing ball becomes audible, shake vigorously for approximately 3 minutes. Shake occasionally during use.
5. Apply in thin coats.
   Hold the can approximately 20–25 cm from the surface and spray using continuous, even movements.
6. Apply 2 thin coats.
   Allow approximately 5 minutes between coats. Several thin coats provide a better finish than one heavy coat.
7. Allow to dry.
   Dust-dry after approx. 20 minutes, touch-dry after approx. 30 minutes and carefully handleable after approx. 60 minutes. Final hardness is reached after approx. 24 hours.
8. Clean the valve after use.
   After use, turn the can upside down and spray for approx. 5 seconds until the valve is clear.

Leather Seat Renovation with Car-Rep Vinyl Spray

The video demonstrates the practical use of Car-Rep Vinyl Spray when renovating automotive leather and vinyl interior surfaces.

Important information

• A completely clean and grease-free surface is essential for durable results.
• No separate primer is required on properly prepared surfaces.
• Always perform a test spray on unknown plastics, leather or existing coatings.
• Several thin coats provide a more even finish than one heavy coat.
• Do not subject the painted surface to heavy use or intensive cleaning until fully cured.