Car-Rep Vinyl Spray Antracit Gray 7015 (400ml)

Car-Rep RAL7015 Slate Grey Vinyl & Leather Spray 400 ml

Car-Rep Vinyl RAL7015 Slate Grey is a flexible spray paint developed for renovating, repairing and recolouring automotive interior vinyl, leather and synthetic leather surfaces.

It is suitable for dashboards, door panels, suitable leather and vinyl seats, centre consoles, gear gaiters and other appropriate automotive interior trim parts.

The special formula contains a built-in adhesion promoter, so no separate primer is required on properly prepared surfaces. The coating flows evenly, remains permanently flexible and does not crack, peel or flake under normal use.

The finished coating has a semi-gloss appearance in RAL7015 Slate Grey and is suitable for restoring worn, faded or discoloured automotive interior components.

What can it be used for?

• Renovating vinyl surfaces
• Recolouring suitable leather and synthetic leather
• Painting and restoring dashboards
• Door panels and interior trim
• Centre consoles
• Gear gaiters and smaller interior components
• Restoring worn, faded or discoloured automotive interior parts

Main benefits

• Developed for vinyl, suitable leather and synthetic leather surfaces
• Built-in adhesion promoter
• No separate primer required on properly prepared surfaces
• Permanently flexible coating
• Does not crack, peel or flake under normal use
• Good flow and even application
• Semi-gloss finish
• Fast drying
• Heat resistant up to +150°C
• Easy aerosol application

Product information

Instructions for use

1. Clean the surface thoroughly.
   Remove all dust, grease, silicone, wax, care products and other contamination. The surface must be completely clean and dry.
2. Matt the surface if necessary.
   Lightly matt glossy, damaged or previously painted surfaces if required, then clean thoroughly again.
3. Carry out a test spray.
   On unknown materials or existing coatings, first check adhesion and colour in an inconspicuous area.
4. Shake the can thoroughly.
   Once the mixing ball becomes audible, shake vigorously for at least 3 minutes. Shake occasionally during use.
5. Apply in thin coats.
   Hold the can approximately 20–25 cm from the surface and spray using continuous, even movements.
6. Apply 1–2 thin coats.
   Allow approximately 5 minutes between coats. Several thin coats provide a more even finish than one heavy coat.
7. Allow to dry.
   Dust-dry after approx. 20 minutes, touch-dry after approx. 30 minutes and handle-dry after approx. 60 minutes. Final hardness is reached after approx. 24 hours.
8. Clean the valve after use.
   After use, turn the can upside down and spray for approx. 5 seconds until the valve is clear.

Leather Seat Renovation with Car-Rep Vinyl Spray

The video demonstrates the practical use of Car-Rep Vinyl Spray when renovating automotive leather and vinyl interior surfaces.